IGBT Drivers
IGBT driver DI28-17-E-2
IGBT Drivers
| VCES [V]: | 1700 |
| Visol [V]: | 4000 |
| Iout [A]: | 8 |
| QG [uC]: | 5600 |
| Channels: | 2 |
| Top [°С]: | -40..+85 |
- Documents and certificates
- Datasheet IGBT driver DI28-17-E-2
- Application Note Open PDF
- Description
Two-channel plug and play IGBT driver designed specifically for 34 mm IGBT modules with voltage up to 1700V.
- Applications
- Converters for solar and wind energy
- Uninterruptible Power Supply (UPS)
- Electric transport
- Frequency converter
- Active rectifiers
-
Additional Information
DI28-17-E-1 is a dual-channel plug and play IGBT driver designed for IGBT-modules with baseplate width of 62 mm (MIAA) and voltage class up to 1700 V. The advantage of plug & play drivers is that they are ready-to-use out of the box and do not require any conversion boards.
The maximum drive pulse current is +/- 8 А. The gate output voltage is +15/-8 V at the logic interface level. Insulation test voltage of 4 kV АС.
The driver can be operated in a wide temperature range from -40 to +85 °C.
It has a compact size of 105х60х26 mm thanks to its well thought-out design.
The driver can be connected to the IGBT module by soldering to the module’s control pins or with a wired connection.
The driver has two modes of operation: the direct control mode allows you to control a switch of the IGBT module regardless of the state of the other switch, while the half-bridge mode prevents simultaneous opening of two switches of the IGBT module.
The driver provides short-circuit protection of transistors and has a function of a soft IGBT shutdown that protects the transistor from destruction. The driver also has undervoltage protection.
Using drivers from the manufacturer of the IGBT modules guarantees the best compatibility taking into account specifics of these IGBT and saves time on selecting a suitable driver, while the cost of a mass-produced driver is much lower than a proprietary driver.
In addition, Proton-Electrotex offers ample opportunities for customizing the IGBT drivers at the request of the customer:
- Ability to change the input interface and pin configuration
- Possibility to select and install gate resistors for the customer’s operating modes
- Designing drivers for modules in parallel connection
- Designing a custom form factor for the customer's converter
- Driver setup for the customer’s operation mode
- Designing adapter / interface boards
For technical advice or purchasing the DI28-17-E-1 driver please contact our Sales Department.
